UV lamp for non destructive test

Thu, 25 Jun 2026 11:12:14 +0800

When e-commerce throughput is the name of the game, every second saved on curing is a second earned on the bottom line. We built this UV lamp to clear the jam at inspection and curing, so you can run fast without giving up quality. What you get under the hood It’s a high-pressure mercury vapor lamp, tuned to a stable spectral output centered at 365nm. At 20mm working distance, peak irradiance hits above 1,200 mW/cm². The reflector is high-purity aluminum with a dichroic coating, so UV gets reflected hard and IR heat is pushed away — substrate temperature stays under an 8°C rise even on long runs. Dose uniformity across the cure window is held within ±5%, measured and certified. That means photoinitiators get consistent energy, and cross-linking stays repeatable. Lamp life is rated to 8,000 hours, with controlled lumen depreciation. The quartz envelope is ozone-free, which keeps ventilation simpler. Why it plays nice with real schedules Supply is flexible, and deadlines are tight. This lamp helps by cutting dwell time and letting you push line speed on UV-curable inks and coatings. The spectral profile stays stable, so cure repeatability holds job to job. You see faster cycles, fewer rejects from under-cure, and less downtime chasing lamp changes. The payoff is a line that can handle demand spikes without burning overtime. Here are the details that keep it honest Match the lamp to your reflector geometry and system voltage. A mismatch wastes output and can cook hot spots into the cure. Make sure your power supply can handle the cold-start inrush; if it sags, you’ll shorten lamp life. For steady performance, check output quarterly with a spectral radiometer, and keep the reflector surface clean so peak irradiance stays where you expect it.

Non on Top UV Lamp

UV lamp for non destructive test